Mod Details
PremiumNo Difficulty
Mod ID1158
Creditevilution
For
Linkhttps://dev.evilution.co.uk/mod/450-fuel-flap-solenoid.htm Copy to ClipboardFuel Flap Solenoid Removal
Remove the rear light on the fuel flap side.
You do this by removing the 2x 10mm plastic nuts from the top and bottom of the side of the light.
Hinge the light away from the car…
…and disconnect the wiring connector.
You can now see the fuel flap solenoid.
Open the boot and look to the right hand interior panel. Remove the Torx20 screw…
…and then pull the interior panel away from the car.
Arrowed below are the 2 fixing bolts.
Use a Torx25 bit to remove these.
Lift the solenoid up and then right to remove it from the car.
Disconnect the electrical connector and it is free.
On refitting, make sure the rod goes back through the hole arrowed below.
Refit the new one in the reverse of removal.
Can’t Fill With Fuel
Knocking It Free
Sometimes a few knocks on the white plastic solenoid can free it allowing it to move. Using a 10mm socket, remove the rear light on the same side as the filler cap, removing the light can be seen here.
Tap it a few times while trying the unlock botton on your key, this should eventually free up the mechanism to allow it to move properly.
I’m Low On Fuel With No Tools
You are only left with a single option, pull the cap open with all your might, it will break the plastic catch on the inside of the cap. The cap can be replaced at a later date when a new one has been purchased.
If you are lucky enough to have some torx bits, you can remove the filler cap cover by removing all of the torx bolts around the outside. The lowest bolt is a dummy and doesn’t need to be removed.