Accelerator Pedal

Mod Description
Moritz G dismantled the accelerator pedal and measured the resistances should you need to double check yours.
Mod Details
PremiumNo Difficulty Mod ID881 CreditMoritz G For450 Fortwo452 Roadster Linkhttps://dev.evilution.co.uk/mod/accelerator-pedal.htm Copy to Clipboard

The smart accelerator (gas) pedal is a “fly by wire” design, this means that it controls the throttle body electronically and not through the use of a bowden cable like older cars. It measures the position of the pedal comparing resistances over 2 pairs of tracks.

The readings that he got were as follows.

These are the 2 set resistances for the central tracks:
Pad 1 to pad 5 = 1.22K Ohm
Pad 2 to pad 4 = 1.23K Ohm

These are the measurements for pedal when not pressed:
Pad 1 to pad 6 = 825 Ohm
Pad 2 to pad 3 = 800 Ohm

These are the measurements for pedal when fully pressed:
Pad 1 to pad 6 = 1.54K Ohm
Pad 2 to pad 3 = 1.51K Ohm

Yours won’t be exactly the same (probably) but your readings should be very close.