Brake Pipe Replacement

Mod Details
PremiumYes Difficulty Mod ID1266 Creditevilution For450 Fortwo451 Fortwo452 Roadster453 Fortwo/Forfour454 Forfour Linkhttps://dev.evilution.co.uk/mod/brake-pipe-replacement.htm Copy to Clipboard

It’s a fairly common failure or advisory on an MOT.

Normally it’s just the tester panicking and the corrosion can be sanded off and the pipes painted. However, sometimes the pipes are just too far gone and the corrosion causes a hole.

You have 2 options.

Expensive but easy = go to smart and buy the pre-formed pipes and fit them.
Cheap but extra work = make your own brake pipes.

Considering the pre-formed pipes are expensive and making your own is 1/3rd of the price, let’s make them.

Remove The Old Pipe

Obviously we need the old one off, not just to make room though. We need it for a template. Unbolt it from each end. I think you are old enough to work out what size spanners you need.

The pipes are clipped to the chassis along the route. Unclip the pipes.

On the rear, the pipes connect to hoses to allow for the suspension movement.

You just have to pull the clip out…

…then you can throw a spanner on each side and disconnect the 2.

You now have your template to copy.

Pre-formed pipes are expensive but a coil of unformed brake pipe is fairly cheap. This kit cost £15 on eBay.

It’s 3/16″ (4.75mm) copper nickel, also known as kunifer, cunifer or cupronickel. It doesn’t work harden like normal copper pipes but it is slightly harder to form. Most importantly though, it’s far more resistant to corrosion.

In the kit I bought, I got the 10mm male connections…

…and the 10mm female connections


Attention

The rest of the information held in this guide is locked to Supporter 6, Supporter 12, Supporter 12+, and Business members of Evilution only.

Use the buttons below to login or find out about becoming a premium member.